7
- Setting Fiber on the Fiber Holder
A
C
Close the front cover
B
D
11
- Remove the Wedge
12
- Open the Front and Back Cover
13
- Take out Connector
14
- Fitting Boot
8
- The Fiber Cleaver
9
- Checking Cut Dimension
5
- Cleaning Bare Fiber
6
- Screening Fiber
2
- Setting Connector
3
- Install boot onto fiber as shown
4
- Removing 0.9 Wire Coating
A
Grip
B
15
- Completion
1
- Preparing Connector
A
B Open the lock lever
10
- Inserting Fiber
A
C
1. Open the middle cover
B
D
Small amount of bending is normal
Be sure to wear Safety Glasses
2 - Set circular groove of connector
tightly onto semicircular ridge “U”
shaped shelf of Jig.
Make sure there is no space between the
wedge and the connector, if there is, re-
align the products before proceeding.
Approxima
tely 30 mm
4 A - Remove 0.25 mm or 0.9 mm fiber
jacket remover. coating, using
appropriate fiber jacket remover.
4 B - Removing appropriate length of
the fiber jacket
Pull
5 - DO NO T USE DIRTY GAUZE!
6 - Bend fiber several times by moving it
with your finger back and fourth.
IF FIBER BRAKES, START WITH A
NEW FIBER FROM THE BEGINNING.
7B - When fully pushed forward guide
member should not be visible from the
back end of the fiber holder
7D - SET THE FIBER ALONG THE GROOVE
TIGHTLY BEFORE CLOSING THE BACK COVER.
8 - A - Insert slider
B - Set the fiber holder to the Cleaver
C - Set the fiber holder tightly
D - Push the cover of the Cleaver
SET THE FIBER HOLDER TIGHTLY!
A
B
C
D
10A - Set the fiber holder to the guiding rail
10 B - Slide holder slowly until it is stopped.
BE CAREFUL NOT TO HIT THE EDGE OF FIBER!
10C - See diagram
10D - CHECKING WHETHER THE FIBER IS
BENDING OR NOT (IMPORTANT)!
Guiding Rail
Length of bare fiber: 9~11 mm
CLICK!
Push the arm to remove the wedge
PULL OUT WEDGE AND OPEN COVER.
CLICK!
IF OUT OF TOLERANCE,
REWORK FROM
PROCEDURE(4)!
Close the cover in the order of above
LENGTH OF 0.9 BUFFER IS WITHIN 2 MM !
<2mm
1
2
3
X
Clean bare fiber with a lint-
free Gauze Pad moistened
with pure Alcohol
X
up
down
left
right
30
o
degree
GUIDE MEMBER MUST BE PUSHED AS
FAR FORWARD AS POSSIBLE.
2. Insert until sounding click
