CONITEC GALEP-5, Руководство пользователя

Страница: 8 / 30

Inserting devices
For the selected device an exact position of the device pins in relationship to the GALEP socket is displayed
by the software within the action window, which is shown for <program>, <verify>, <blank check>, <read> and
<erase>.
Most devices are inserted with the device's pin # 1 directed to the lever of the GALEP socket and with the
opposite end of the device aligned to the opposite end of the socket (see image above). Positioning your
device into the GALEP socket should be done carefully, with regard to correct pin orientation.
Exceptions: GALEP-III can not provide all the different programming voltages at each of the socket pins. This
makes it necessary to rotate or move some of the devices on the socket. Therefore it is essential to keep in
mind, that the device always must be inserted exactly as displayed in the Action window.
Such limitation obviously does not apply to the GALEP-4 and GALEP-5 ASIC pin hardware capabilities, but
both old and new GALEP share some common programming algorithms, requiring the
rotation or movement
of some devices even when using GALEP-4/-5.
Please note / disclaimer: Devices incorrectly inserted into the GALEP risk permanent damage . If a device
is incorrectly inserted even once, it should under no circumstances be used any more, as it's correct function
can no longer be guaranteed. Incorrectly inserted devices can also cause damage to the GALEP, and will
void it's warranty
Device Specific Help
See the links below for device specific information
We highly recommend to study the manufacturers data sheet too. You´ll find a link to most of the
semiconductor manufacturers via
www.aufzu.de .
EPROM EEPROM FLASH
PLD MCU RAM
Serial (EE)PROMs SPECIAL JTAG