10
ENGLISH
QL107
Installation (continued)
PLACEMENT
- Push the cabinet (A) against the wall . Level the unit by adjusting the four leveling legs and checking the alignment of the sink
using a carpenter’s level .
- Please note, leveling feet are intended for leveling the cabinet, not height adjustments . It is not recommended to extend leveling
feet by more than 0 .4” (10mm) . Overextending the leveling feet may render the sink cabinet unstable .
DRAINAGE
The tailpipe (not supplied) previously installed to the drain can now be connected to your household plumbing . In some cases, your household
plumbing will have to be modified to ensure proper drainage. If so, please consult a licensed plumber to complete
needed modifications.
SUPPLY LINES (NOT INCLUDED)
Connect the supply lines to your home’s water supply as per manufacturer’s instructions .
Open the hot and cold water supply valves and check to make sure they have
been installed to appropriate inlet ports . Check for leaks . Run hot and cold water
uninterrupted for about one minute to remove any residue from the lines .
Maintenance
CARTRIDGE REPLACEMENT
- Turn off the water supply to the faucet .
- Unscrew the handle lever (1) . Loosen the set screw (2) with the hex key and remove the handle body (3) .
- Gently unscrew the decorative cap (4) and retaining nut (5) .
- Pull the cartridge (6) out of the faucet body (7) and replace it with a new ceramic cartridge . Ensure new cartridge is seated properly
with the locating pins in appropriate place .
- Secure the cartridge in place using the retaining nut (5) .
- Gently tighten the retaining nut (5) using a wrench . Do not overtighten .
- Reinstall the decorative cap (4) . Slide the handle body (3) back onto the cartridge and make sure it rotates freely . Secure the handle
body (3) in place using the set screw (2) and reinstall the handle lever (1) .
- Turn the water supply to the faucet back on .
- Operate the faucet to make sure everything works correctly and check for leaks .
Handle
Lever (1)
Faucet
body (7)
Cartridge (6)
Retaining Nut (5)
Decorative
Cap (4)
O-Ring (8)
Set Screw (2)
Handle
Body (3)
