Step 1:
Install the foam pads [4 for
36” step, 12 for 74” step ] on the flat
spots located on the bottom edge of
sidewall.
Step 2:
Using a rubber mallet install
one of the 3” supports into the slot
located on the bottom of sidewall.
[36” step will have 2 sidewall, 74” will
have 4 sidewall]. Install one plug into
each sidewall.
Step 3:
Turn the step assembly over
and finish installing the 3” supports,
[6 for 3-step, 8 for 4-step] into the front
and back slots of each step location .
Step 4:
Using a rubber mallet, install
the four handrail posts into the middle
slots of the top two step locations on
the left sidewall, and the top two step
locations of the right sidewall. Handrail
posts must be seated into the slots.
Step 7:
Secure handrails using 1- # 10 x
1¼” screw into each post at pre-marked
locations.
Step 8:
Install the steps [finished edge
out] by placing over the male lugs on the
step sidewall and hitting downward with a
rubber mallet.
Step 5:
Install towel rack/cup holder
over the handrail posts with the towel rack
to the outside of step, tap in place using
the rubber mallet. Towel rack/cup holder
may be positioned anywhere on the post.
Step 6:
Tap the handrails into the
handrail posts.
Confer - Signature Spa Steps
ASSEMBLY AND INSTRUCTION MANUAL
NOTE: STEP PARTS ARE DESIGNED FOR A TIGHT FIT, USING LIQUID SOAP
DETERGENT WILL MAKE ASSEMBLY EASIER.
MADE IN THE U.S.A. BY:
Signature spa step 3-00-SSS-1 12/13
Printed in U.S.A.
97 Witmer Road
North Tonawanda, NY USA 14120-2421
800-635-3213
Fax: 716-694-3102
www.conferladders.com
email: [email protected]
Confer_SigSpa-US-12-13r3:layout 12/26/13 4:12 PM Page 2
