5
Step 13.
Step 12.
Carefully submerge the unit into the pool. Add water to
the side panels through the water fill openings located
near the top of each side panel. When completely filled,
press the supplied (white) plugs into the openings on
both side panels.
Water fill
openings
on both
side panels.
To prevent
algae, add
a cup of
household
bleach
(optional).
Step 14.
Joining two Pool Entry Systems.
When joining two units together, the deck connectors will not be used.
Assemble both units and position the in-pool unit
in the desired location, after filling it in the same
manner as step #12. Allow approximately two (2)
inches of clearance between the side of the pool
(pool liner) and the Entry System. Make any nec-
essary height adjustments to ensure that all four
(4) threaded adjustors are supporting the unit, that
the unit is level and does not wobble, and that the
underside of the top step is about (1/2) inch above
the pool top seat. The outside unit should rest on cement patio blocks.
Position and level the outside unit so that both units can be joined
using the six (6) 1/4-20 x 1" machine screws and hex nuts. The hex
nuts should be on the outside of the fastening flange of the side
panels (See diagram on pg 2). Press the large plugs into the fill
opening of the outside unit. It is not necessary to fill the outside
unit with water
.
Note: Gate instructions and hardware are supplied with the gate.
Tilt the unit to allow the steps to fill with water. When
bubbling ceases, steps are filled. Steps must be filled
completely to prevent floating.
Note: Two people are
required for this operation
Position the PES with attached deck connector and drill
three pilot holes. Attach to deck using 3 #10 x 1-1/4" Self
Tapping Screws. Keep 2" clearance between unit and pool
wall.
Attach with 3 #10 x 1-1/4"
Self Tapping Screws
Safety Information
1) Always follow the manufacturer’s recommendations
for the safe use of all hand tools and equipment.
2) Always use a cordless drill.
3) Do not use the Pool Entry System for any
purpose other than that for which it is intended.
4) When lifting awkward or heavy loads, have
another person help you.
5) Maximum weight on steps not to exceed
400
lbs.
6) Consult your local building department before
installation of your pool and equipment.
Warning: Exceeding the recommended weight
requirement may cause the unit to fail.
Replacement Parts
Thank you for purchasing a C.P.I. product. Although
we make exceptional effort to ensure the quality of
our products, occasionally an error or omission may
occur. If you discover that a part of this product is
missing or defective, please contact us for a
replacement.
In The U.S.A. Call:
(866) 396-2968
or
(716) 283-1826
Or Write To:
Confer Plastics, Inc.
97 Witmer Road,
North Tonawanda, NY 14120 U.S.A.
www.conferladders.com
