Model# CCX-IG - CURVE IN-GROUND POOL STEP
ASSEMBLY INSTRUCTIONS
Safe Installation
To reduce the risk of electrocution, drowning, entrapment, falls, or other serious injury or
death:
Check building codes/permitting.
Consult your local Building Department before installation of your pool and equipment.
Pool/equipment installation must comply with the codes of the authority having jurisdiction and may require permits (e.g.,
building, plumbing, electrical, zoning, etc.).
Use for intended purpose only
• Use only as swimming pool stairs.
• These steps are designed and manufactured for a specific pool wall height and/or deck of the pool - check product
specification and the height of your pool.
Check that you have all required parts.
Check the contents of the carton with the Parts list for this step system. All parts
and hardware are required. If any parts are missing,
DO NOT attempt to assemble or install the steps.
Instead, call Toll
Free U.S. - 800-635-3213 or visit our web site at www.conferladders.com for assistance.
Select an appropriate location
- The step system must be located on a solid base.
Follow all instructions
• For stable, correct assembly and installation, all instructions must be followed completely and in the sequence shown.
• Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used during installation.
Cordless drill only - no corded drills near pool.
Use a cordless drill for assembly and installation. To reduce the risk of
electrocution, NEVER use a corded drill in or around a pool.
Lift safely.
When lifting awkward or heavy loads, have another person help you.
Double check after installation
• Before using the product, after assembly and installation, go over the instructions and procedures again to make sure
nothing has been overlooked.
• Make sure that safety labels are installed and legible.
Stand up both side
panels [A]. Insert panel
brace [B] with vent hole
up into opening located
on [A] then push down
to lock in place.
Step 1
With the thin edge of the
curved riser [C] facing
downward align the lower
tabs with the openings on
part [A] and push in.
Note risers must be
curved inward.
Step 2
2
Confer Plastics “CURVE” In-Ground Pool Step
must be assembled with the treads and risers curved inward
The CURVE Step requires 40 lbs. of sand to complete assembly. The Curve Step with optional add-on requires a total of
70 lbs. of sand. Choose a location close to the swimming pool for assembly. If you have a pool deck it is recommended
to build the step on top of the deck to avoid lifting completed step over the pool wall.
Parts List
2 - Side panels [part A]
4 - Plugs [installed in parts A]
1 - Panel brace [part B]
3 - Curved risers [part C]
4 - Handrail posts [part E]
2 - Deck connectors [part F]
2 - Handrails [part G]
4 - Foot pads [part H]
2 - Treads [part I]
1 - Top tread [part I-3]
Assembly Video
Available online at
www.conferplastics.com
Hardware not provided to fasten step to concrete. Purchase locally.
Hardware Pack
10 - #10 x 1-1/4” screws
2 - Labels-No Jumping/
Diving (pre-installed)
Needed for Assembly:
- Second person to assist
- Rubber mallet
- Funnel
- Cordless Drill
- 1/8” drill bit
- Phillips screwdriver
- Liquid soap or lubricant
- Sand - 40 lbs. for (Curve Step)
- 70 lbs. for (Curve System)
Scale size photo of screw
USE A LITTLE
LIQUID SOAP ON
TABS TO HELP
WITH ASSEMBLY
G
I
C
F
I-3
E
B
A
H
