Position the other end of the tread over
side panel [A]. Move the large flex riser [M]
in or out until it slips up into the groove
located on the bottom of
the large curved tread [O].
It will also be necessary
to align the tabs on the
tread support [N] with
the two openings on
the bottom of the large
curved tread.
Once everything
is in position tap
down on the large
tread to lock onto
panel [A].
Step 28
Install the first tread [I] onto the base
step by placing over the tabs on the side
panels [A] as shown.
While holding the
tread down, tap
inward with a
rubber mallet until
locked in place.
Step 29
Install the short
handrail post [K]
into the lower
opening on the
add-on panel [J]
marked with #3
next to it. Push
the tab on the
post all the way
in; then tap down
to lock in place.
Step 30
Place the medium curved tread [Q] over
the short handrail post and down on to
the tabs located on the add-on panel [J].
Move the riser in or
out until it slips up
into the groove on
the bottom of the
tread, using a
rubber mallet strike
the top of the tread
until locked
onto tabs.
Step 32
CONFER CURVE STEP ADD-ON INSTRUCTIONS (Cont’d.)
At this time add 30 lbs of sand through the
two fill holes located on the add-on panel.
Using a funnel fill the lower hole com-
pletely to the top with sand. Shake the panel
to help settle
the sand. Lower
hole must be
completely filled.
Pour whatʼs left
from the 30 lbs,
into the upper hole.
Using provided cap,
plug the lower fill
hole only. Upper fill
hole must remain open.
Step 25
The next step will require an extra set of hands to help
align the large flex riser [M] and the tread support [N] into
the groove and the openings located on the bottom side of
the large curved tread [O].
Step 26
Fill
Holes
It will be easier to start from
the add-on panel side and
work towards the base step.
Start by placing the large
curved tread in approximate
position over the panels and
flex riser. Next align the tabs
on the add-on panel with the
openings on the bottom side
of large curved tread. Lock
the tread down by striking
top of tread directly over the
tabs with rubber mallet.
Step 27
Next, install the medium flex riser [P]
by sliding down into the slot located on
the add-on panel [J].
Insert the tab located
on the end of flex
riser into the opening
on side panel [A].
Riser will rest on
the top back of
tread below.
Step 31
6
prpd.Confer-CurveStepIGr16:Confer-Step-1_R1 1/3/13 2:26 PM Page 6
