Condair RH 1.8, Инструкция по установке и эксплуатации

Страница: 54 / 68

54 Maintenance
7.4.2.3 Removal and installation of the inlet valve
To remove the inlet valve, the steam cylinder (see Section 7.4.1.1 ) and the cover of the internal water
system (see
Section 7.4.2.1
) must be removed.
1
2
3
4
5
Fig. 14: Removal of the inlet valve
1. Disconnect the electrical cables from the connectors on the inlet valve.
Note: The polarity of the electrical cables does not have to be observed.
2. Loosen the hose clamp and pull the hose off the connector.
3. Loosen the water supply hose and remove the hose.
4. Pull the inlet valve forwards out of the holder in the drain pan and remove it.
5. Use pointed pliers to pull the strainer out of the inlet valve.
The installation of the inlet valve is done in the reverse order of the removal. Before installation, ensure
that the strainer insert is reinstalled in the inlet valve.