Concoa Advantium 1 Plus, Инструкция по установке и эксплуатации, Страница: 10 / 20

7
Using the pin assignments shown in Table 1 and the connector views in Figure 4 and
Figure 5, solder the wires to the appropriate pins. After soldering is complete, slide the
locking nut over the connector body. Snap the cable retainer into the body and then slide
the protective cover over the cable retainer.
Table 1— Remote Alarm Pin Assignments
Protocol
Pin Number
5750011/5740012
Alarm Pin Number
Function
1 1 N.C.
2 2 N.C.
3 3 +12v (provided by the remote alarm)
4 4 Inlet Status
5 5 Alarm.
6 6 Ground (provided by the remote alarm)
CONNECTING ALARM OUTPUTS
The Advantium 1 Plus provides output signals corresponding to the alarm conditions that
it senses. These signals are presented through relay contacts and are brought out to a 4
pin circular connector on the bottom of the alarm. A mating 4 pin connector is provided
to allow for connecting the alarm to other equipment. Pre-made cables are also available.
Contact your local CONCOA Distributor or call 1-800-225-0473 for information. The
relay contacts are configurable. They are factory set as Normally Closed (N.C.) but may
be changed to Normally Open (N.O.) if needed. Refer to the Section “Setting Remote
Alarm Outputs” in the manual for the procedure.
The recommended cable for making an output cable assembly is 22 AWG, 4-conductor
stranded wire (Alpha # 1174C or equivalent). The length of this cable should be limited
to 1500 feet.
Cut the 4-conductor cable to length. Remove the outer jacket of the cable to expose
approximately 3/4 inch of the internal conductors on both sides of the cable. Strip away
1/4-inch of the insulation on each of the conductors.
On the 6-pin connector, slide the protective cover, cable retainer, and locking nut over the
end of the cable as shown in
Figure 6.
Using the pin assignments shown in Table 2 and the connector views in
Figure 6 and
Figure 7, solder the wires to the appropriate pins. After soldering is complete, slide the
locking nut over the connector body. Snap the cable retainer into the body and then slide
the protective cover over the cable retainer.