Copyright
®
2009 by Conceptronic
– All rights reserved
www.conceptronic.net
Page 2 of 6
B.
Upgrade procedure
Note:
The steps described below are based on using the remote control. However, for most part you can
also use the touch buttons on the front panel of the Media Giant. Please note that the “OK” button
on the front panel has the exact same function as the “ENTER” button on the remote control.
1.
Copy the contents of the “
Firmware
” folder to the root of a USB memory stick.
Files included in the Firmware folder
:
CM3PVRAP_1.01.019.tar
:
fw_upgrade.sh
:
install.flash.img
2.
Make sure the Media Giant is completely off. The switch on the back should be on “
OFF
”.
3.
Connect the USB memory stick to the Media Giant.
4.
Turn on the Media Giant on with the switch on the back.
5.
When the menu is loaded, choose “
SETUP
” and press “
ENTER
” on the remote control.
6.
Browse to “
System
” in the Setup menu, browse to “
Firmware Upgrade
” and press “
ENTER
” on the
remote control.
7.
Choose “
Manual
” and confirm by pressing “
ENTER
” on the remote control.
8.
The Media Giant will search for an available firmware version. It will first search the internet, when
that is not possible or no new firmware version can be found on the internet, it will search check the
USB storage device.
Note:
When you do not want the Media Giant to use the internet as firmware upgrade option, you
should remove the network cable from the back.
9.
When a new firmware has been found you will get the message “
New firmware 1.01.019 found.
Continue?
” Confirm this by pressing the “
ENTER
” button on the remote control.
10.
The firmware upgrade will now take place, the progress is displayed in the message “
Please DO NOT
POWER OFF 0% processed.
”. Once the firmware upgrade reaches 100% you will get the message
“
Firmware upgrade successfully
” and the Media Giant will reboot automatically.
11.
You will be presented with the Setup Wizard where you will need to configure the basic settings.
12.
After the Setup Wizard has completed, you can check the firmware version by pressing the “
INFO
”
button on the remote control. The firmware version should be “
2.00.007 / 1.01.019
”.
