Concept2 VP 4120, Руководство пользователя

Страница: 21 / 39

USING THE VACUUM CLEANER
NOTE: Prior to using the vacuum cleaner, please make sure that the filters have been installed properly.
STICK VACUUM CLEANER
1. Switch on the vacuum cleaner using the switch on the stick part holder.
2. After use, switch off the vacuum cleaner with the switch on the stick part holder.
HAND-HELD VACUUM CLEANER
1. Press the latches on the stick part (see Fig. 4) to detach the portable part of the vacuum cleaner.
2. Switch the vacuum cleaner on using the switch on the portable part holder.
3. After use, release the switch on the portable part holder to switch the vacuum cleaner off.
CHECKING THE DUST RECEPTACLE LEVEL
If the suction power of the vacuum cleaner drops or the dust receptacle is full, empty it and clean the filters of
the vacuum cleaner.
MAINTENANCE
As a preventative measure, we recommend emptying the dust receptacle and cleaning the filters of the
vacuum cleaner after each use.
EMPTYING THE DUST RECEPTACLE
1. Disconnect the charging adapter from the power mains.
2. Detach the portable part of the vacuum cleaner from the stick part.
3. Hold the portable part of the vacuum cleaner with the dust receptacle down.
4. Press and hold the dust receptacle latch and turn the dust receptacle slightly to release it (Fig. 5).
5. Remove both filters and empty the dust receptacle of the vacuum cleaner.
6. Reverse the steps to fit both filters and mount the dust receptacle back on the portable part of the
vacuum cleaner.
Fig. 4 Fig. 5
CLEANING AND REPLACING THE FILTERS
The filters of the vacuum cleaner can be cleaned by mechanical shaking and cleaning with a soft brush.
Heavily fouled filters can be washed after this step and cleaned with a soft brush in lukewarm water. Do not
use detergents.
It is important to let the wet parts dry thoroughly. Wet filters might be damaged if used for
vacuuming!
Do not use a hair dryer for drying!
Note: Wet cleaning can cause more wear and tear of the filters, and a correspondingly shorter service
life.
• The filters should be cleaned or replaced whenever they are visibly fouled, or when the suction power
decreases. The filters should be checked after each use of the vacuum cleaner.
• Never use the vacuum cleaner without properly installed filters to avoid damage to the appliance.
• Suitable filter types are available at your local retailer, or they can be ordered from the manufacturer.
CLEANING AND MAINTENANCE
The vacuum cleaner and its accessories can be cleaned with a damp cloth.
Do not immerse the power cord, charging adapter, or appliance into water or any other liquid.
Do not use aggressive substances for cleaning, such as solvents or abrasives!
TROUBLESHOOTING
Problem Cause Solution
Motor does not run.
Accumulator is discharged. Charge the accumulator.
Reduced suction power.
Dust receptacle full or clogged.
Empty and clean the dust
receptacle.
Obstructed filter. Clean or replace the filter.
Clogged nozzle or turbo brush of
the vacuum cleaner.
Check and clear the air passage
on the suction and discharge
sides.
Although the accumulator is
fully charged, the operating
time is shorter than 2 minutes.
The accumulator service life is over.
The accumulator needs to be
replaced.
Vacuum cleaner heats up.
Slight heating of the vacuum cleaner is normal and cannot be
considered a failure.
ACCESSORIES
The following accessories can be purchased with the unit:
Fine filter
Ord. No. 42390810 Price: See price list
Coarse filter Ord. No. 42390809 Price: See price list
Accumulator Ord. No. 44291599 Price: See price list
SERVICE
Any larger maintenance or repairs requiring intervention into the internal parts of the product shall only be
performed by an authorized service
EN EN
41 40 VP 4120 VP 4120