70
71
EN
EN
SC2500
SC2500
BATTERY REPLACEMENT
1. Press the button below the
display to open the dashboard.
2. Unscrew the battery cover.
3. Pull out the battery using
the cord located on the top
of the battery.
1. Press the button below the
display to open the dashboard,
remove the battery cover.
2. Alight the groove of the
battery with the groove in the
electric scooter. Make sure that
the cord is always visible on
the top of the battery.
3. Tighten the battery cover.
Then press on the dashboard.
Always make sure that the
display is firmly attached.
1. Removing the battery from the electric scooter
2. Installing the battery into the electric scooter
CLEANING AND MAINTENANCE
•
Always make sure that the battery and charger of the electric scooter are disconnected from the power supply. The
electric scooter must be switched off.
•
Dampen a soft cloth with clean water and use it to clean the electric scooter. Never use an excessive amount of
lubricating oil when performing bearing maintenance.
•
It is forbidden to clean the electric scooter using water spray or immerse it into water and other liquids. This would
permanently damage the electrical components.
Maximum charging current
2 A
Input voltage
100-240 V AC
Frequency
50–60 Hz
Output voltage
42 V
Output current
1.5 A
SAFE USING OF THE BATTERY
Stop using the battery in the following cases:
•
Use the battery of the electric scooter only in accordance with local laws. Contact a qualified person to remove and
replace the battery.
•
Do not touch any substances leaking from the battery. If the battery starts to produce an unpleasant odour or gets
too hot, stop using it.
•
Do not use the electric scooter during charging. Always disconnect the battery from the charger before ride and
installation.
•
Do not let children and animals touch the battery!
•
To ensure proper operation of the battery, pay attention to the storage and charge temperature. Always observe
the temperature range given in the specifications.
•
Always follow local laws when transporting lithium batteries. Lithium batteries are considered dangerous.
•
The battery contains dangerous substances, never open the battery. Do not insert anything into the battery.
•
It is forbidden to charge a lithium battery that has been over-discharged. These batteries represent a safety hazard,
hand them over to the appropriate collection point.
•
If the internal temperature of the battery exceeds 45 °C, the protection system will be automatically activated.
•
Do not charge the battery if the outdoor or indoor temperature exceeds 40 °C.
•
Never leave the electric scooter on a direct sunlight. This could damage the battery.
•
Use only original chargers to charge the electric scooter.
CHARGING PROCEDURE
First charging method:
•
Open the charging port cover and make sure that the charging port is clean and dry.
•
Connect the charging device to the battery and the other end to the power supply (100-240 V).
•
If the indicator on the charger lights up red, the battery is charging properly. If the indicator does not light up, check
the connection to the mains.
•
If the indicator on the charger lights up green, the battery is charged to 99 %. Stop charging the battery. Prolonged
charging of the battery affects its lifespan.
Second charging method:
•
Remove the battery from the electric scooter. Remove the silicone cover from the charging port, then connect the
DC connector of the charger to the charging port of the battery.
•
Plug the power cord into the charger and the second port into a wall outlet (100-240 V). Check whether the charger
indicator is on.
Charging port
Battery interface
If the indicator on the charger lights up green, the battery is charged, disconnect the charging device from the battery.
•
After charging, cover the charging port with the silicone cover which protects the port from dust and prevents
contact with foreign metal objects that could cause a short circuit.
Содержание SC2500
Страница 82: ......
