Concept2 OPO5890, Руководство пользователя

Страница: 67 / 76

INSTALLATION OF THE APPLIANCE
Caution!
Risk of electric shock! Before installation, disconnect the power cord from the wall outlet. Otherwise there is
a risk of death or electric shock.
• Defects caused by improper installation are not covered by the warranty.
• Installation is the responsibility of the customer not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to inco-
rrect installation.
• All guards must be placed firmly in their appropriate place in a way they cannot be removed without using
special tools.
• Install the appliance at least 550 mm over electric cookers or electric cooking plates and at least 650 mm
over gas cookers or gas cooking plates.
• Extracted air should not be led to a chimney intended for discharge of flue gases and combustion products
or a shaft serving for ventilation of rooms where fireplaces are situated.
• Any bend of the ventilation pipe should be ≥120°C.
• The room must be well ventilated during cooking.
Connection to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the
appliance.
• Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
• Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is
connected to the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad
protective connection.
When installing the appliance, follow these steps:
1. Remove all the packaging and marketing materials before first use.
2. Mark the position of the centre of the cooking hob on the ceiling above the hob (Figure 3). Prior to
installation itself, ensure there will be enough space vertically between the hood and the cooker hob,
when the hood will be hanging in its place (at least 550 mm from the electric hob or 650 mm from the
gas hob), (Figure 4).
3. Mark and drill the holes for mounting the cooker hood holder for attaching on the ceiling (Figure 4 and
Figure 5).
4. Use wall dowels and screws to fasten the holder to the drilled holes in the ceiling (Figure 6 and Figure 7).
Note: Wall dowels and screws are not included in the package.
5. When the hood is attached, install the flexible outlet duct to the outlet opening (Figure 8). Use a redu-
cer fitting 150/120 mm in diameter, if required. Insert the other end of the flexible duct in the opening
prepared in the ceiling.
Note: Flexible duct (piping) is not included.
6. Put the upper and lower chimney cover onto the mounted cooker hood holder (Figure 9).
7. Attach the upper chimney cover to the holder, but do not fully fasten the screws, leave them slightly
loose so that the lower chimney cover does not slide down and it can lean against the screws (Figure 10).
8. Attach the cooker hood body to the holder on the ceiling (Figure 11 and Figure 12).
9. Plug all the connectors into the distribution box.
10. Plug the power cord into the wall outlet. Fasten the screws on the upper chimney cover and lower the
lower chimney cover fully (Figure 13).
67
EN
OPO5890