Concept2 OPI3075, Руководство пользователя

Страница: 47 / 56

47
EN
OPI3075
USER MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene reasons.
Ventilation mode
The extracted air is discharged through the flexible outlet duct to the ventilation shaft out of the room. If the appliance
is equipped with a carbon filter,
remove it (see chapter Cleaning and Maintenance).
1. Press the button (1), (2) or (3) to switch the appliance to the desired power level.
2. Press the button (5) to switch the appliance lighting on/off.
3. Press the button (1) to turn the appliance off.
Recirculation mode
If there is no possibility of discharging the extracted air out of the room, you can use the recirculation mode. In this
case, the extracted air is filtered
through the metal fat filters and the carbon filter
An active carbon in this filter
absorbs the smell. Air, free from the smell, flows back into the room through openings situated in the upper chimney
cover. When the recirculation mode is used,
it is necessary to purchase and install
the appropriate carbon filters
(see chapter Cleaning and Maintenance).
Note:
When the recirculation mode is used (carbon filter installed), the extracted air output can drop.
CLEANING AND MAINTENANCE
1. Disconnect the power cord from the wall outlet or switch off the circuit breaker of the appliance before cleaning
and maintenance.
2. To clean the appliance outside, use a damp cloth, a soft brush or a fine sponge, and then wipe it dry.
3. Do not use coarse abrasive cleaning agents or sharp metal scrapers for cleaning of the appliance as this could result
in surface scoring.
4. Do not use steam jets to clean the appliance!
5. Never leave aggressive or acidic substances (lemon juice, vinegar) on enamelled or stainless parts of the appliance.
Cleaning and replacement of filters
Metal fat filters
When the appliance is in common use, the metal fat filters should be
checked or cleaned every month. In case of more frequent frying or
deep frying, shorten this interval.
Do not use the appliance without the metal fat filters properly
installed!
1. Remove the metal filters as shown in Fig. 1.
2. Let the metal filters soak in warm water with addition of
a detergent or put them into a washer with a cleaning agent and
set temperature
below 60 °C . In case of soaking in warm water,
clean the metal filters with a fine brush, rinse them with clean water
and let them dry.
3. Reinstall dried out filters.
Fig. 1