153
EN
MNV5860
Note:
1. 1. In the upper part of the illustration for the installation of the top plate it is shown how many spacer bars and
which screws must be used for installing the spacer bars to the control panel of the dishwasher.
2. The spacer bars are put together; the side without the „pins“ shall be attached to the bottom side of the
dishwasher control panel.
3. The „pins“ on the bottom side of the bars must be removed (cut off). This step must be done otherwise the top
plate would not fit properly.
4. After removing the „pins“, attach the spacer bars with the included screws to the bottom side of the dishwasher
control panel.
5. In the upper part of the illustration for the installation of the top plate it is shown which screws must be used for
the number of spacer bars.
6. After attaching the spacer bars to the bottom side of the dishwasher control panel, the head of the screw must
be at the same level (it must not stick out) as the bottom side of the spacer bar.
Adjusting door spring strength
• The spring strength is preset only for the appliance door itself. After attaching the cover plate the weight of the
door changes.
• You adjust the strength of the springs using the screws located on the bottom part of the front of the dishwasher
(Pic. 16).
• Setting of the springs is correct when the open door stays in the position and does not fall down.
Pic. 16
Pic. 15a
Pic. 15b
Unscrewing the short screws
Screwing the long
screws
Magical paster
Magical paster
Содержание MNV5860
Страница 3: ...4 MNV5860 CZ ...
Страница 35: ...36 SK MNV5860 ...
Страница 99: ...100 LV MNV5860 ...
Страница 131: ...132 EN MNV5860 ...