76
MNV3560
EN
Water inlet connection
• Prior to connecting the supply hose to the water mains, make sure the water pressure
complies with values of 0.04-1.00 MPa. In case of higher water pressure, a pressure
reduction valve must be installed.
• The dishwasher can be connected to hot (maximum 60°) or cold water. Connection to
cold water is recommended. A hot water supply may not necessarily be effective for very
stained dishes, as it reduces the time of the washing program too much.
• Connect the supply hose to a water tap with a 3/4” thread (Figure 17). Make sure the supply
hose is not bent, pressed, or tangled.
• When an old dishwasher is replaced with a new one,
a new water supply hose must
always be used
to connect to the water source; the old supply hose must never be reused.
• In case the water mains are new or were not used for a long time, let a sufficient volume of
water run out before connecting the water supply hose so that pipes may get flushed and
any potential deposits are prevented from entering the dishwater.
Fig. 17
Fig. 18
Connecting to the mains
• Make sure the mains voltage corresponds to the values on the rating plate.
• Only use grounded electric sockets.
• Never use adapter sockets, connectors and extension cords. They might create a risk of fire due to overheating.
• The dishwasher supply cord plug must remain freely accessible after the dishwasher is installed.
• Only a qualified specialist may perform any changes in connection.
DISHWASHER INSTALLATION
When installing the dishwasher, follow these instructions:
1. Check the dishwasher after delivery.
Note: All the dishwasher functions have been checked thoroughly during
manufacture. Small water stains may be left after these tests. They will
disappear after the first washing.
2. Fix the cover plate on the dishwasher door.
3. Adjust the door lifting spring strength.
4. Connect the water supply hose to the water mains.
5. Connect the drain hose to the water sink.
6. Connect the dishwater to the mains.
7. Fix the condensation strip to the plate bottom following the instructions
on the condensation strip backside. Dampness will condense on it, and the
wooden desk will thus be protected.
8. Push the dishwasher into the selected place in the cupboard.
9. Level the dishwasher horizontally by adjusting the feet. In the centre of the
lower side front section, there is a screw allowing adjustment of the back
height. Check the horizontal position using a level.
10. Make sure the dishwasher is secured in the cupboard against displacement by
fixing sheet metal plates and wood screws fixed to the upper board or/and to
the side board of the corpus.