56
LKV5260
EN
USER MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene reasons. Wash
all removable parts with warm soapy water.
After installing the refrigerator, leave the appliance standstill for at least half an hour before connecting to the mains.
It is necessary to allow the cooling gases to set down. Then you can connect the refrigerator to the mains and let it run
for 2-3 hours to stabilize a normal operating temperature. A slight odour may occur during this time. It will go away as
soon as the appliance starts to cool. Then put fresh or frozen food inside the appliance.
Note
: If a power failure occurs during the first run, wait for at least 5 minutes before switching on again or connecting
to the mains.
Setting the Temperature of Refrigerator Zone
1. Open the door of the appliance.
2. Press and hold the button (5) for 3 seconds to unlock the control panel.
3. Press the appropriate buttons (1), (2), (3) or (4) on the control panel to set the temperature inside the refrigerator.
4. The set temperature will be indicated on the control panel by the illuminated button of the selected temperature.
Note:
•
After connecting the refrigerator to the mains, the control panel lights up for 3 seconds.
•
The temperature inside the refrigerator is preset to 4°C.
•
The freezer temperature is automatically set to -18°C.
Setting the Temperature of Freezer Zone
•
The freezer temperature is set automatically according to the set temperature in the refrigerator and it cannot be
altered.
Unlocking the Control Panel
•
Press and hold the button (5) for 3 seconds to unlock the control panel.
•
After unlocking the control panel, all the buttons for setting the temperature start to flash for 2 seconds.
•
After this time, it is possible to set the temperature inside the refrigerator.
•
After 15 seconds of inactivity, the control panel is locked automatically.
Refrigerator defrosting hole
•
The refrigerator compartment defrosts automatically during operation. The defrost water is collected in the
evaporation groove and it is drained into the evaporation container where it evaporates spontaneously.
•
The defrosting hole must be cleaned regularly. Clean with a solution of edible soda and lukewarm water.
•
Make sure that food packaging does not touch the back wall of the refrigerator, it may interrupt the automatic
defrost process - water will not run into the evaporator groove, but to the bottom of the appliance.
Note
: Frozen water droplets may appear on the back wall of the refrigerator, it is a common phenomenon not a defect
of the appliance.
Содержание LKV5260
Страница 2: ...2 LKV5260 CZ...
Страница 63: ......