90
EN
IDV1360
Fig. 6
OPERATING INSTRUCTIONS
•
Areas designed for cooking only – electric cooking zones – are indicated on the hob. The diameters of the cooking
zones are derived from the usual dimensions of cookware.
•
Only the surface inside the indicated diameter is heated; other surfaces remain relatively cold and can be used as
put aside areas.
•
The temperature sensor prevents the cooking zone under the ceramic glass plate from overheating.
•
The light up “H” symbol on the indicator position of the input power levels signals increased temperature of the
cooking zone after being switched off (residual heat). The symbol will go off as soon as the cooking zone has cooled
down to such a temperature that there is no risk of burning.
•
The inputs of the cooking zones can be regulated within the range of 9 levels, which can be set by pressing the
button with respective indicators on the control panel. An acoustic signal sounds each time the button is pressed.
The response time for pressing a symbol is 1 second. For this period, it is necessary to hold your finger on the
symbol.
Note:
•
The touch control is activated by placing a finger on the required
symbol on the ceramic glass hob.
•
Use the entire fingertip, not just the tip, to operate the touch buttons
(Fig. 6).
•
Keep the control panel clean and dry. Even a small amount of water
on the control panel can make it more difficult to operate the buttons.
Do not place anything on the control panel of the hob.
•
The sensors do not respond to matte and dark colours (do not use
black gloves).
•
Make sure not to switch on the appliance accidentally. Risk of serious
burns!
Before first use
Prior to first operation of the appliance, you should wipe it with a wet cloth.
Switching on the hob
Touch the ON/OFF symbol (5) for 1 second to activate the hob.
Switching on a cooking zone
1.
Press and hold the on / off button (5) for 1 second to switch on the hob. After turning on
one beep will sound and the display will show “-” or “-”, indicating that the board is in standby mode.
2.
Press to select the cooking zone you want to use. The indicator next to the button will flash. Then set
required power level by repeatedly pressing the symbol “-” (2) or “+” (3) for the selected cooking zone to the value
1 to 9.
Note:
•
You can change the desired cooking zone performance at any time during cooking.
•
If you do not set any required power level within 1 minute of switching on the induction hob, it will automatically
switch off.
•
In case the “
U
” symbol is light up on the control panel (6), it indicates that the cookware’s bottom diameter is too
small or it is made of an unsuitable material for induction cooking. Check the cookware bottom, if it is suitable for
induction cooking.
•
Use a smaller cooking zone or a cookware with a larger diameter of the bottom for cooking, or use cookware that
is suitable for induction cooking.
Switching OFF the cooking zone
1.
Press the “-” symbol on the control panel (6) repeatedly to reduce the power to “0” and switch off the hob.
2.
By pressing the ON/OFF button (5) you can turn off the hob.
