EN
47
ETV2860
3. Put the unit on the edge of the cabinet and run the power cord through the rear wall of the cabinet so that its
plug is accessible after installation.
4. Push the unit carefully to the selected place in the cabinet. Be careful not to squeeze the power cord.
5. Attach the unit to the cabinet by screwing 4 screws in the holes in the side walls of the unit. The holes can be
seen after opening the door.
6. Plug the supply cable in the wall outlet.
Follow the installation instructions:
1. Remove all the covering and marketing materials from the unit before the first use.
2. For the required built-in box dimensions see Fig. 8a, 8b. For the sake of efficient air circulation the unit has to be
located according to the dimensions on the pictures and the design of the cabinet must enable air flow into its
bottom part.
Fig. 8a
A 600 mm
B 565 mm
C 560 mm
D 90 mm
E 24 mm
F 5 mm
G 118 mm
H 113 mm
J 80 mm
K 70 mm
L 25 mm
Fig. 8b
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, unplug the power cord from the mains (pull out the plug or switch off the circuit breaker).
2. Remove the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
SERVIS
Lighting bulb of the internal space of the oven
The bulb of the internal space lighting is special, with high thermal resistance (25 W, 300°C).
To replace it, proceed as follows (Fig. 9):
