Concept Smoke Screen SENTINEL S30, Инструкция по установке и эксплуатации

Страница: 12 / 16

Page 12 of 16
LED AND SOUND INDICATIONS
The Smoke Screen provides on-board status monitoring via an LED and a sounder. Indications displayed are:
LED colour Buzzer sound
Output relay status
change
Indication meaning
●
Flash twice every 2 seconds 1 short beep every 5 seconds Ready n/c to open. Smoke Screen overheating*.
●
Flash once every 2 seconds 1 long beep every 60 seconds Ready n/c to open. Cover open and/or the external tamper is open/not jumpered.
●
Flash twice every 5 seconds 1 short beep every 5 seconds UPS n/c to open.
UPS monitoring set to on and UPS power fail or UPS not
connected.
●
Flash once every 5 seconds 1 short beep every 5 seconds Nil. Mains power failure (UPS fitted).
●
Flashing 1 short beep every 5 seconds Ready n/c to open. Heater fault*.
●
On
Continuous beep for 30
seconds then 3 short beeps
every 5 minutes
Nil. Smoke Screen heating to operating temperature*.
● ●
Alternating None Nil.
Smoke Screen in ‘Programming Mode’.
●
On None Ready n/c to closed.
Smoke Screen ready to operate.
●
Flashing None Nil.
Smoke Screen receiving ‘Alarm Set’ and ‘Trigger’ signals but
waiting for a ‘Hold Off’ to activate.
●
Flashing 1 beep every 2 seconds Verification n/c to open.
Smoke Screen has activated and smoke has been produced
– indication will continue until both ‘Alarm Set’ and ‘Trigger’
are reset.
●
On 1 short beep every 5 minutes Fluid status n/c to open Low fluid
– first warning, Smoke Screen will still activate.
●
Flashing
1 long and 1 short beep every
5 minutes
Nil. Empty fluid or fluid bag removed*.
* = Smoke Screen will not activate in this state.
Once resolved, any remaining fault indications can be cleared by removing and restoring mains power to the Smoke Screen.