Assembly Instructions
Assemble the Seat Cont.
5. Line up the four holes. Place
one washer on the bolt head side
and thread thorugh the pre-ma-
chined hole. Then, place an
additional washer and nut on the
opposite side of the bolt head.
6. Use one half-inch wrench to
hold the bolt in place. Then use
the second half-inch wrench to
tighten the bolt. Repeat steps
5 and 6 until all four bolts are
secured.
Assemble the Seat Cont.
7. Next, slide the cylinder with
attached base into the machined
hole of the tilt mechanism. The
cylinder into the tilt mechanism
is a compression fit. No addition-
al assembly is required.
8. Bring the chair upright.
