5
CAUTION
(Cont.)
for a long period of time (several
months or more) since during this time
the battery could leak in the product.
9. Properly discard dead batteries as
soon as possible since dead batteries
are more likely to leak in a product.
10. Do not store this product, or the
batteries provided with or identified for
use with this product, in high
temperature areas.
Batteries that are stored in a freezer or
refrigerator for the purpose of
extending shelf life should be protected
from condensation during storage and
defrosting. Batteries should be
stabilized at room temperature prior to
use after cold storage.
INSTALLATION INSTRUCTIONS
1. Never install telephone wiring during
a lightning storm.
2. Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
3. Never touch uninsulated telephone
wires or terminals unless the telephone
line has been disconnected at the
network interface.
4. Use caution when installing or
modifying telephone lines.
INSTALLATION
Choose Your Location
To Install One 9 Volt Battery
Your unit must be placed on a hard, flat
surface and connected to both the
telephone wall jack and an AC power
source. Allow at least one inch to the
rear and four inches above the unit for
ventilation.
One 9 volt battery (not included) is
required to maintain your Outgoing
Announcement and recorded messages
during a power failure. If there is a
power failure and the battery is not
installed, both your Outgoing
Announcement and recorded
messages will be lost.
1. Make sure AC adaptor is unplugged
from electrical outlet.
2. Using a small Phillips type
screwdriver, remove the screw located
in the battery compartment on the
bottom of the base and lift the battery
compartment door.
