Attach the top pants clip bar
to the rotating hanger by
inserting mounting pegs into
the hanger’s two keyhole
openings. Push in and pull
down to lock.
The bottom clips can be
adjusted by loosening the
knob (on the telescopic pole)
and moving the pole up and
down, depending upon the
length of pants. Clip pants
as shown and steam.
Please note: some pants
may be too long to use the
bottom clips. If that is the
case, just simply use the
top clips and let your pants
hang freely.
OPERATING
INSTRUCTIONS
FILLING THE WATER TANK
(PRIOR TO PLUGGING IN THE APPLIANCE)
Remove the water tank using
handle on front of tank. Fill
reservoir using opening on top
of tank by holding it under a
source of cold running water
until it is filled to the desired
level. Do not overfill. Position the water tank
on the base and make certain it is seated
properly in the unit.
DO NOT FILL THE TANK WITH HOT WATER.
DISTILLED OR FILTERED WATER IS BEST.
and will be ready to use when green light
is on (B).
3. Push button on T-nozzle – light will go on
and steam will start.
Always hold the
nozzle about ½ inch from fabric while
steaming.
USING ROTATING HANGER
This unit comes with a rotating hanger.
To use the hanger, simply place on top of
pole firmly. It is now in place to rotate 360˚.
Hang your garment and steam away wrin-
kles. Turn as you wish.
USING PANT CLIP SYSTEM
This fabric steamer is equipped with a pant
clip system for holding pants taut for faster
and more effective steaming.
top
