S
ETTING THE
C
UTTING
M
ODE
O
PERATION
4-31
UGE048/1103
CSC Combination Puller/Cutter
Be sure that the Cut On/Off button is OFF.
Press the Select button
to activate the cutting mode
you want. A mode is active when the LED next to it is
lit. Each time you press Select the control activates the
next available mode. Continue pressing the Select button
until you get the mode you want. Then go on to the next
step.
Make any additional entries
required for the
cutting mode you have selected. Press the Set button.
Use the adjustment arrows to change the number listed on
the Length or Time display. Press Set button to
return to normal operating mode.
●
For Timer mode:
Use the Set button and
Adjustment arrows to change the time (in seconds,
to three decimal places). NOTE: the decimal point
cannot be moved.
●
For Encoder mode:
Use the Set button and
Adjustment arrows to change the cut length. If the
cut length does not equal the set length, adjust the
prescale value.
See Control Instructions Encoder
Area, Section 4.
●
For Product mode:
Use the Set button and
Adjustment arrows to change the hold-off time. In
Product mode, the desired length is set by the elec-
tric eye that sense the end and initiate a new cut. To
prevent unwanted double cuts, a hold-off (or one-
shot) timer is built into the cutter control. After a cut
is made, the hold-off time displays in the Display
window (in seconds, to three decimal places) and
begins counting down to zero. No cutting occurs
until the countdown is completed. Make sure the
new value is less than the time between cuts. NOTE:
70-80% of the expected time between cuts is recom-
mended.
●
For Flywheel mode:
Use the Set button and
Adjustment arrows to change the cutter blade speed.
If you are not sure what blade speed to use, start
fast and work your way down to slower speeds.
See
Appendix B: All About Cutter Blades.
●
For Follower mode:
Press the Blade Speed button;
use the Adjustment arrows to enter the number of
blades (1, 2, 4, or 8). Press the Set button to accept
the value. Use the Set button and Adjustment arrows
to set the cut length.
1
2
3
