Comunello Automation MOWIN, Инструкция по эксплуатации

Страница: 22 / 86

8
1) T. MOT. (Max. Motor Timer programming time 4 minutes)
The control unit comes with a motor power supply time of two minutes (T. MOT. LED OFF).
The motor running time must be programmed when the window/shutter is open/down, in the following man-
ner: Press the SEL button until the T. MOT LED flashes, then press and hold the SET button; the shutter will
begin to move upwards. Once the desired position has been reached, release the SET button; at this very mo-
ment, the motor running time will be stored and the T. MOT LED will remain lit. If you are using an automation
which has a stop limit, we recommend that you set a time which exceeds the stop limit of the shutter by a few
seconds. If you want unlimited motor time, perform the same programming procedure, holding down the SET
button for less than two seconds; the T. MOT LED will remain lit and the unlimited time function will be set.
The procedure may be repeated if a mistake is made during programming.
2) WIND SPEED (Wind Safety threshold programming)
Displaying the programmed Wind threshold: The Wind Safety threshold may be displayed in the following way:
use the SEL button to navigate to the WIND SPEED LED position; the LED will double-flash the same number
of times as the stored Wind Safety threshold (each WIND SPEED LED double-flash corresponds to an increase
of 5 km/h), (for example: 5 WIND SPEED LED flashes = 25 km/h). Wind Safety threshold selection from 5 to 40
km/h The sensor is supplied with a default Wind Safety threshold setting of 25 km/h (WIND SPEED LED OFF).
The Wind Safety threshold may be programmed in the following way: use the SEL button to navigate to the
WIND SPEED LED, then press the SET button to start the programming procedure: the WIND SPEED LED will
doubleflash at the same time (each WIND SPEED LED double-flash corresponds to an increase of 5 km/h).
Press the SET button when the desired threshold has been reached; at that moment the selected value will
be stored in the memory and the WIND SPEED LED will remain lit (for example: 5 WIND LED doubleflashes =
25 km/h). The procedure may be repeated if a mistake is made during programming.
3) SUN SENSOR (Sun sensor ON/OFF)
Enabling the Sun sensor: The control unit comes with the Sun sensor disabled (SUN SENSOR LED OFF). The
Sun sensor may be enabled in the following way: press the SEL button until the SUN SENSOR LED flashes,
then press the SET button briefly; at this moment the SUN SENSOR LED remains lit and the Sun sensor will
be enabled. Repeat the procedure to disable the Sun sensor.