91300366 - Rev.00 - 15.11.18
Rule of the first saved Remote control:
When programming remote controls the following rule is applied: if
the first remote to be saved is a rolling code type, the receiver will
subsequently accept only rolling code remotes (thus ensuring greater
anti-intrusion security); if the first remote to be saved is a fixed code
type, the receiver will accept both fixed and rolling code remotes,
although only the fixed part of the latter will be identified.
For the
deletion
of remote control codes
please check the installation and user ma
-
nual or the video with the detailed pro
-
gramming tutorial.
L) RESET
If it becomes necessary to
reset
the control unit to restore the factory
settings, press the
SELECT
and
SET
keys together; this will cause all
the
indicator LEDs
to light simultaneously followed immediately by
the control unit switching off.
WARNING!:
by the above mentioned procedure the stored re
-
mote codes
WILL NOT be deleted
; where necessary follow the above
mentioned procedure of deletion.
G) PAUSE TIME - Automatic closing time programming
The automatic closing is factory disabled;
to enable it after a fixed period of time
(max. 4 min.) proceed as follow:
1. By the key
SELECT
, position yourself on the blinking
LED L6
“PAUSE TIME”
;
2. Press once the key
SET
;
3. Wait for a desired time interval;
4. Press the key
SET
again;
MAX 4 MIN
5. The
LED L6
will remain steady on and that period of time would
be set as time interval.
H) Remote control code programming (total opening)
PP CHANNEL
gives an input to activate the total
stroke stored.
PPED CHANNEL
gives an input to activate the pede
-
strian or partial stroke the total stroke
Up to 120 remote controls can be memori
-
zed in the control unit receiver.
Its programming is performed as follow:
1. By the key
SELECT
, position yourself on the blinking
LED L3
“CODE TX”
;
2. Press key
SET
once to memorize the
PP channel
;
3. Send the selected code with your remote control;
4. The
LED L3
will remain steady on for a second to indicate that
programming has been completed.
5. The
LED L3
starts to blink again to indicate that you have 10
additional sec. to store a new code;
6 On expiry of those 10 sec. the
LED L3
will remain steady on.
I) Remote control code programming (partial/pedestrian ope-
ning)
1. By the key
SELECT
, position yourself on the blinking
LED L3
“CODE TX”
;
2. Press key
SET
twice to memorize the
PPED channel
;
3. Send the selected code with your remote control;
4. The
LED L3
will remain steady on for a second to indicate that
programming has been completed. The extra time of 10 sec. to
store a new PPED channel is then preview as for the PP chan
-
nel.
To watch videos you will need to have an internet connection and to install in your Tablet or Smartphone a
QR code
reader
, available on
APPLESTORE
for iOs devices or on
GOOGLE PLAY
for Android devices.
