9
Chapter 2 Installation
2.1 Hardware Setup
Follow the instructions below to complete the hardware setup.
Non-stackable
This device is not stackable – do not place units on top of each other, otherwise
damage could occur.
BACK PANEL
The figure below shows the back panel of the device.
Power ON
Press the power button to the OFF position (OUT). Connect the power adapter to the
power port. Attach the power adapter to a wall outlet or other AC source. Press the
power button to the ON position (IN). If the Power LED displays as expected then
the device is ready for setup (see section
2.2 LED Indicators
).
Caution 1:
If the device fails to power up, or it malfunctions, first verify that the
power cords are connected securely and then power it on again. If the
problem persists, contact technical support.
Caution 2:
Before servicing or disassembling this equipment, disconnect all power
cords and telephone lines from their outlets.
Reset Button
Restore the default parameters of the device by pressing the Reset button for 10
seconds. After the device has rebooted successfully, the front panel should display
as expected (see section
2.2 LED Indicators
for details).
NOTE: If pressed down for more than 60 seconds, the VR-3033
will go into a
firmware update state (CFE boot mode). The firmware can then be
updated using an Internet browser pointed to the default IP address.
Содержание VR-3033
Страница 1: ...261099 037 VR 3033 Multi DSL Wireless Router User Manual Version A1 0 March 1 2016...
Страница 57: ...56 5 3 3 UPnP Select the checkbox provided and click Apply Save to enable UPnP protocol...
Страница 64: ...63 A maximum of 100 entries can be added to the URL Filter list...
Страница 106: ...105 Enter the MAC address in the box provided and click Apply Save...
