- 6 -
6. Install the Black Vinyl Cap on the top element.
7. The two stainless steel V-Bolt Clamps are used to
secure the mounting plate to the customer supplied
mounting pipe described earlier in this manual. When
the antenna is installed on the mounting pipe, tighten
the V-Bolts evenly so the length of the exposed
threads is approximately equal. Any V-Bolt should be
tightened evenly from side-to-side with an equal
amount of thread above each nut.
8. Connect the center conductor of your coaxial feedline
to the studded band clamp. The shield from your
coaxial feedline must connect to the base plate where
you connect your radial wires.
Frequency MHz
Approximate Overall Length
7.000
34 Feet 5 inches
7.125
32 Feet 10 inches
7.175
32 Feet 7 inches
7.300
33 Feet 3 inches
Figure 1
COMTEK 40 Meter
Vertical Antenna
Assembled Diagram
