Comtech EF Data CIM-550, Инструкция по установке и эксплуатации

Страница: 105 / 460

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
79
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
b defines the IF band, with 1 = 70MHz, 2 =
140MHz
c defines RX only, with 1 = RX/TX, 2 = RX only.
Example: EID=455011 (CiM-550, Rate 3/4 Turbo
Codec, 70 MHz band, RX/TX)
Faults
and
Status N/A 5 bytes,
first 3 bytes
alpha-numerical
4th and 5th
bytes, value of 0
or 1
Query only. Unit returns the current fault and status
codes for the Unit (hardware), Tx Traffic and Rx
Traffic, in the form abcde, where:
a = Unit fault status, b = Tx Traffic status,
c = Rx Traffic Status, d = Change in Fault Status
since last poll (0 = none, 1 = change), e = Change
in Unit Configuration since last poll (0 = none, 1 =
change)
Unit faults:
0 = No faults
1 = Power supply fault, 5 volts
2 = Power supply fault , 12 volts
3 = Power supply fault, -5 volts
4 = Power supply fault, 18 volts
5 = Power supply fault, -12 volts
6 = RAM load fail
7 = Tx synthesiser lock
8 = Rx synthesiser
9 = Power cal Checksum error
A = FPGA main chain load fail
B = Turbo FPGA load fail
C = CiM IP Module Fail
Tx Traffic status:
0 = Tx traffic OK
N/A FLT? FLT=abcde (see
description for
details of
arguments