Wireless ADSL Modem User’s Manual 55
User Selected Annex Mode:
This allows you to select from Annex A and Annex B.
Trellis:
Trellis Code is an advanced method of FEC (Forward Error Correction). This
field allows you to enable or disable the Trellis Code. By default, it is always enabled.
Handshake Protocol:
This field allows you to select from the following ADSL
handshake protocols: Autosense – G.dmt first (default), Autosense – T1.413 first,
G.dmt/G.lite, T1.413, G.dmt, and G.lite.
Wiring Selection:
This field allows you to enter the wiring selection for the RJ-11.
Tip/Ring is the default for the ADSL Bridge/Router without the inner/outer pair relay.
Available types are Auto, Tip/Ring (default), and A/A1, where Tip/Ring is the inner-most
pair of wires on the RJ11 and A/A1 is the second inner-most pair.
Bit Swapping:
This field allows you to enable or disable the upstream bit swapping. Bit
Swapping is disabled by default.
Route Table
The
Route Table
page displays the routing table and allows you to manually enter a
routing entry. The routing table will display the routing status of Destination, Netmask,
Gateway, and Interface. The interface br0 indicates the USB interface; lo0 indicates the
loopback interface; ppp1 indicates the PPP interface. The Gateway is the learned
Gateway.
