COMRADE R8, Руководство пользователя

Страница: 6 / 14

05 06
5.3. - MICRO-HEADSET INSTALLATION OF EXTERNAL:
Plug the external micro-headset
connector into the jack of "SP. & MIC"
of the transceiver as shown in the figure
below.
5.4. - BATTERY INSTALLATION:
-When attaching the battery, make sure the battery is in parallel and in good contact with
the aluminum chassis. The battery bottom is about 1 to 2 centimeters below the bottom
of the radio's body.
-Align the battery with the guide rails on the aluminum chassis and slide it upwards until
a "click" is heard.
-The battery latch at the bottom locks the battery.
-Turn off the radio before removing the battery.
-Slide the battery latch, at the bottom of the radio's body, in the direction indicated by the
arrow.
-Slide down the battery for about 1 to 2 centimeters, and then remove the battery from
the radio's body.
6.-BATTERY CHARGING:
Use only the charger specified by the manufacturer. The charger's LED indicates the
charging progress.
Please use the supplied charger to charge up the battery pack. And refer to the operation
way as below:
1) Put the adapter*s DC plug into charger*s DC jack which located at rear of charger.
2) Put the adapter into AC power*s socket. The charger*s LED will illuminate green light.
It means that the power has been connected.
3) Put the battery pack or transceiver with battery pack in charger cup. The LED will
illumination red light. It means that the battery pack is been charging.
4) When the red light goes out, and the green light illumination. It means that battery pack
is charged fully.
5) Pull out the adapter from AC power*s socket and take out battery pack.
Note:
1) Make sure the radio is switched off during charging.
2) Overcharging may affect the battery performance.