15
Scan the specific frequency ONLY
This scanning mode will specifically scan a frequency; usually used when the
signal is weak and has been lost during other type of scanning mode.
LNB Settings
This settings need to follow the instruction from the Satellite’s LNB spec. If
you already have other working device that can receive the signal from the
satellite (i.e. Set-Top Box), you may refer the settings for that device. If you
still have problem with LNB settings, please contact your satellite dish
provider for correct information.
DiSEqC1.2 motor control setting
Compro S350/S300 supports DiSEqC 1.2 version. If you have installed motor
that compatible to DiSEqC, it may aim to different satellite to receive different
satellite’s channels.
3. 2 ports 22KHz switch / 2 ports mini DiSEqC switch /
4 ports DiSEqC1.0 switch / 4 ports DiSEqC1.2 switch
These four settings are similar to Single
mentioned above. The difference is
these four settings have connected the
LNB to the TV card through a switch.
Please refer to the picture in each
setting to confirm which switch you are
using, then continue with the advance
settings.
Each of these mode will have 2~4 tabs
to switch between different satellites (i.e.
under “4 ports DiSEqC1.2 switch” will
have Port S1, Port S2, Port S3, and
Port S4 tab)
Note
Compro S350 supports up to 4 ports DiSEqC switch. Before using autoscan,
you may need to confirm the LNB connection and settings are correctly setup.
After channel scanning, ComproDTV will receive the correspondent channels
of the satellite. For information on above settings, please refer to your satellite
installer.
Please always press “Apply” before using
“Autoscan” and “DiSEqC motor control”.
