10
6.3.2
Automation Tab
The Automation tab provides control over the unit’s
automatic
control command broadcast behavior when the specified system
Automation Events occur. Automation commands may be sent to 3rd
party devices via standard CEC, or customizable RS-232.
Note: Sending RS-232 commands requires the use of a compatible
HDBaseT Receiver with an RS-232 port.
1)
Event:
Use the dropdown to select the Automation Event to
configure. Available Automation Events are:
–
Power On:
This unit is powered on.
–
Out A Source Active:
The currently selected input changes
from inactive to active.
–
Out A Source Lost:
The currently selected input changes
from active to inactive.
■
CEC:
Enable or disable sending a CEC command when the
currently selected Automation Event is activated.
Note: CEC support must be enabled on the connected HDMI
device.
■
Delay:
Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined CEC command.