Comprag A7513, Инструкция по эксплуатации

Страница: 29 / 96

+7 (800) 777-83-75(звонок бесплатный)
www.v-p-k.ru A7513
5.6 Changing drive belt
Fig. 5.6 Changing drive belt
Open the front and left side panel. Remove the protective metal grid. Loosen the 2 screws
(1) and the 2 nuts (1) securing the bracket of the air end by turning them 2 revolutions.
Loosen the 2 bolts (4) of the support and the 2 corresponding nuts (3) on the tensioner using
a wrench. Remove the old belts from the pulleys and install the new belts. After installing the
new belt, tighten the belt with the appropriate tensile force (see section
5.3 Checking Drive Belt). Tighten the 2 bolts (4) of the support and the 2 corresponding nuts
on the tensioner. Tighten the 2 screws and the 2 nuts of the bracket of the air end. Check
the belt tension within four hours of the
compressor’s operation in accordance with
section 5.3. Move the protective metal grid back.
5.7 Changing air-oil
separator
The separating component (1) is located
within the separator tank. Open the front
panel in order to change it. Unscrew the
bolts (2) and carefully remove the top cap
of the tank. Disconnect hoses if they
make it difficult to remove the cap.
Remove the spent separator and install
a new one in its place. Refasten the tank
cap.
Fig. 5.7 Changing air-oil separator