Compool Lx220, Инструкция по установке и эксплуатации

Страница: 11 / 16

9
Compool Lx220
Operating Instructions
Water Flow To Panels Switch
AUTO: Automatically turns system on whenever solar energy is available. Switch should be
left in this position during normal use.
OFF: Manually turns solar system off.
ON: Manually turns solar system on, regardless of solar availability. This position should be
used only to test system operation.
Water Temperature Dial
Allows solar system to heat the water up to set temperature. After that temperature is reached,
the solar system is automatically turned off. The Dial ranges from approximately 74 - 110
degrees Fahrenheit
To determine your optimum temperature setting, set Dial to the “HOT” position and observe the
water temperature over a period of a few days. When the maximum desired temperature of the
pool is reached, rotate the Dial counterclockwise until the SOLAR ON Light just goes out. Once
this setting is identified, it will not be necessary to change the Dial.
Power On Light
When Lit, indicates that electrical power is applied to the Control.
Solar On Light
When lit, indicates that solar system is on. Note: the filter pump timer must be set so that the
filter pump operates during that time of the day when solar energy is available.
Pool Cleaner Delay Expired Light
Whenever the solar system is turned on, an electronic delay automatically turns off the pool
cleaner for a few minutes. This protects the pump from damage caused by air in the solar panels
at system start-up. Note: to enable this feature, an optional Relay Kit (model RLY-SC) must be
added to the Control. This light indicates that the delay has expired.