6
Compool Cp3400
Plumbing Requirements
Plumb system in accordance with recommended hydraulic schematic.
1.
Spa should be at or above the level of the pool. If spa is attached to pool, provide a dam
between the two bodies of water, this allows the spa to overflow into the pool. If spa is not
attached to pool, an overflow, sufficient in size to carry full pump-flow, must be installed
between the spa and pool.
2.
Plumb 3-port valve on the suction-side of the filter pump, so that center port of valve is
connected to the filter pump. Connect spa suction to one port, and pool suction to the
other port.
3.
Plumb 3-port valve on the output-side of the heater, so that center port of valve is
connected to the heater. Connect spa return to one port, and pool return to the other port.
4.
Plumb 3/4” spa makeup line (incorporating a 3/4” ball valve and a 3/4” check valve).
During pool circulation, some of the pool water needs to enter the spa to keep it
chemically balanced and full of water. The ball valve adjusts the amount of bypass.
5.
If a Spa-side Remote is to be used, install a 3” to 6” length of 1.5” Sch. 40 pvc pipe in the
spa wall so that the Spa-side Remote will not be submerged. Positioning the top of the
pipe 1/2” below the coping. The pipe should extend beyond the finished surface and will
be cut back after tile work is completed. Connect a 1/2” conduit and run back to Power
Center. Use sweep elbows for turns.
CONTROL PANEL
POWER CENTER
SOLAR
SENSOR
CLEANER
PUMP
CVA-24
CVA-24
HEATER
CVA-24
SOLAR
PUMP
VACUUM
RELIEF
WATER
SENSOR
SKIMMER
FILTER
PUMP
FILTER
CVA-24
MAIN
DRAIN
HW-5B
JET
PUMP
BLOWER
WATERFALL
POOL
LIGHT
SPA-SIDE
REMOTE
AIR
INTAKE
SPA
LIGHT
SPA
POOL
1
2
3
4
5
7
6
8
9
10
11
FREEZE
SENSOR
