Competition Electronics DH16A-10DT, Инструкция по эксплуатации

Страница: 9 / 14

-13- -14-
Applicable model: DH16A-12/52/62/82/83DT
DH16A-12/52/62/82/83DTQ
Before installation, position the location where the controller unit is
mounted. Please operate it according to the following steps:
1. Open the controller and remove the back case at the bottom
with the special tool.
2.
Use the provided drilling template to accurately locate and drill
the required holes. The four drilling holes are marked "B".
Then insert the screw anchors in the holes.
3. Use the screws provided to mount the back case on the wall. Be
sure to draw the wiring through the large centre hole in back
case, and keep level.
4.
Connected accurately the system wiring following the label
enclosed on the rear.
5. Put the unit back and fasten it by using the special tool.
Before installation, position the location where the controller unit is
mounted. Please operate it according to the following steps:
Applicable model: DH16A-10/20/30/50/60DT
DH16A-10/20/30/50/60DTQ
1. Open the controller and remove the back case at the bottom
with the special tool.
2.
Use the provided drilling template to accurately locate and drill
the required holes. The four drilling holes are marked "B".
Then insert the screw anchors in the holes.
3. Use the screws provided to mount the back case on the wall. Be
sure to draw the wiring through the large centre hole in back
case, and keep level.
4.
Connected accurately the system wiring following the label
enclosed on the rear.
5. Put the unit back and fasten it by using the special tool.