Adding a Second Drive
5
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks TL881/TL891 Family MiniLibrary System Drive Upgrade Procedure
Comments:
Part Number:
127511-002
File Name:
b-ch1 Adding a Second Drive.doc
Last Saved On:
7/12/00 7:16 PM
Replacing
To replace the skin cover on the Base Module:
1.
Slide the skin cover over the module until it touches the front panel.
2.
Insert the four screws (2 each side) through the skin cover into the Base
Module. Do not tighten the screws yet.
3.
Position the front edge of the skin cover so that it is flush against the
back of the front panel.
4.
Tighten the four screws (2 each side) into the Base Module.
Removing and Replacing the Cover Plate
Removing
To remove the cover plate from the Base Module:
1.
If the Base Module is a desktop model, remove the skin cover as
described in “Removing and Replacing the Skin Cover (Desktop Models
Only).”
2.
Disconnect the power and interface cables at the rear of the module.
3.
Unscrew the captive screw in the center of the cover plate (Figure 3).
4.
Slide the cover plate one-half inch toward the rear of the module.
5.
Lift the cover plate off the Base Module.
