Installation
5.
Attach an inner rail to each side of the router.
See Figure 2-3 for an illustration.
a.
With the spring latch facing away from the router and the circular grasping
hole facing the front-side of the router, align the front-most screw hole on the
router with the center screw hole on the rail.
NOTE:
The front-side of the router has air vents, as illustrated in Figure 2-3. The
back-side of the router has all of the interconnects.
Using this alignment, two screw holes will be aligned and the rail will extend
out from the front-side of the router approximately 8 inches.
b.
Secure the rail to the router using two #6-32x.312 Phillips screws.
Back End
Spring Latch
Front End
Inner Rail
Figure 2-3: Attaching inner rails to the router
c.
Repeat Step 5 to attach the inner rail to the other side of the router.
6.
Install the router in the rack.
See Figure 2-4 for an illustration.
a.
Move the ball-bearing slide on each of the outer rails towards the front of the
rack.
b.
From the front-side of the rack with the front-side of the router facing out,
align the inner and the outer rails and slide the inner rail into the outer rail.
2-6
Network Storage Router N1200 Installation Guide
COMPAQ CONFIDENTIAL
Writer: Mark Garza File Name: c-ch2 Installation.doc
Codename: Myst-Riven Part Number: 283394-002 Last Saved On: 4/26/02 2:59 PM
