Installation
Figure 2-2: Aligning the bracket face with the rack
c.
With the outer rail assembly face flush against the inside front of the
rack-mounting holes, insert and tighten the top and bottom screws of the
bracket face. Use two of the 10-32x.6 Phillips screws.
Do not insert a screw in the center hole of the bracket face. This hole will be
used when the front bezel blank is mounted to the rack.
d.
Loosen the flat-head screw on the rear extension bracket of the outer rail
assembly.
e.
While holding the outer rail assembly level, extend the rear extension bracket
to the inside rear of the rack.
WARNING: To reduce injury or equipment damage, the rails must be level.
If the rails are not level, the router cannot be installed correctly and might
fall.
f.
Attach the rear extension-bracket face to the rear of the rack, using two of the
10-32x.6 Phillips screws.
g.
With the outer rail assembly in place, tighten the flat-head screw that
connects the rear extension bracket to the outer rail.
h.
Repeat Step 4 to attach the other outer rail assembly to the other side of the
rack.
Network Storage Router N1200 Installation Guide
2-5
COMPAQ CONFIDENTIAL
Writer: Mark Garza File Name: c-ch2 Installation.doc
Codename: Myst-Riven Part Number: 283394-002 Last Saved On: 4/26/02 2:59 PM
