Compaq StorageWorks HSG60 Скачать руководство пользователя страница 7

Страница: 7 / 7

Page 7

6. If enclosure power is applied, verify that the LED displays

a Charge Test state (see

Figure 3

for LED locations and

Table 1

for the proper display state).

7. Following ECB initialization, verify that the LEDs display

either a Charging or Charged state (see

Figure 3

for LED

locations and

Table 1

for the proper display state).

8. Press the release tab on the old ECB and pivot the lever

downward.

9. Remove the old ECB from the enclosure.

10. Install the blank panel in the vacant ECB bay.

Updated StorageWorks Model 2100 and
2200 Enclosure ECB LED Definitions

Table 1

replaces Table 6–1 “ECB Status LED Displays” in the

Compaq StorageWorks Model 2100 and 2200 Ultra SCSI
Controller Enclosure User Guide.

IMPORTANT:

Make sure to identify the existence of this updated table in the

user guide.

Table 1: ECB Status LED Displays

LED Display

ECB State Definition

Startup: Checking temperature and
voltage. If this state persists for more than
10 seconds, then a temperature fault
exists.
Backup: When power is removed, a low
duty cycle F

LASH

indicates normal

operation.

Charging: The ECB is charging the
battery.

Charged: The ECB battery is charged.

Charge Test: The ECB is ascertaining
whether the battery is capable of holding
a charge.

Temperature Fault Indications:
•

When this indication displays, the ECB
battery charging is suspended until
the temperature fault has been
corrected.

•

When this indication displays, the ECB
battery is still capable of backup.

ECB Fault: Indicates the ECB has
faulted.

Battery Fault: The ECB determined the
battery voltage is incorrect or the battery
is missing.

LED Legend:
O

LASHING

Содержание StorageWorks HSG60








Результаты поиска

Содержание StorageWorks HSG60

Отзывы:

Бренды по названию

Популярные бренды

Compaq StorageWorks HSG60, Карта установки

Результаты поиска

Содержание StorageWorks HSG60

Отзывы:

Бренды по названию

Популярные бренды