QVision Operations and Installation Guide
v, vi
FEDERAL COMMUNICATIONS COMMISSION NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
§
Reorient or relocate the receiving antenna
.
§
Increase the separation between the equipment and receiver.
§
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
§
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this
device that are not expressly approved by Compaq Computer Corporation may void the
user's authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI
connector hoods to maintain compliance with FCC Rules and Regulations
.
CANADIAN NOTICE
This equipment does not exceed the Class B limits for radiated emissions as described in
the Radio Interference Regulations of the Canadian Department of Communications
.
GERMAN NOTICE
COMPAQ computers, when tested with the COMPAQ High-Resolution, Multi-Scanning
Color Monitor, were evaluated for compliance to the requirements of ZH1/618 in the
Text Mode (640 x 480) using MS-DOS Version 3.31 (or higher) and BASICA as
published by COMPAQ.
