Compaq.com - Compaq Presario Maintenance and Service Guide - 2250, 2410 ES, 2510, and 4240 ES Series
United States December 10, 2002
Maintenance & Service Guide
Presario 2250 Series
2510, 2410 ES & 4240 ES Personal Computers
|
|
Power Cord Set Requirements
The voltage select switch feature on the computer allows it to operate from
any line voltage between 120 or 240 volts AC.
The power cord set (flexible cord and wall plug) sent with the computer meets
the requirements for use in the country where the computer was purchased.
Power cord sets for use in other countries must meet the requirements of the
country where the computer is used. For more information on power cord set
requirements, contact a Compaq authorized dealer, reseller, or service
provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.00 feet (1.8 m) and a
maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will be
used.
3. The power cord set must have a minimum current capacity of 10A and a
nominal voltage rating of 125 or 250 volts AC, as required by each country's
power system.
4. The appliance coupler must meet the mechanical configuration of an EN 60
320/IEC 320 Standard Sheet C13 connector, for mating with appliance inlet
on the Switch Box.
Country-Specific Requirements
Power Cord Set Requirements by
Country
Country
Accredited
Agency
Applicable
Note
Numbers
Australia
EANSW
1
Austria
OVE
1
Belgium
CEBC
1
Canada
CSA
2
Denmark
DEMKO
1
Finland
SETI
1
France
UTE
1
Germany
VDE
1
Italy
IMQ
1
Japan
JIS
3
Norway
NEMKO
1
Sweden
SEMKO
1
Switzerland SEV
1
United
Kingdom
BSI
1
United
States
UL
2
NOTES:
1. The flexible cord must be <HAR> Type HO3VV-F, 3-conductor, 1.0 mm2
conductor size. Power cord set fittings (appliance coupler and wall plug) must
bear the certification mark of the agency responsible for evaluation in the
country where it will be used.
2. The flexible cord must be Type SJT-2 or equivalent, No. 18 AWG, 3-
conductor. The wall plug must be a two-pole grounding type with a NEMA 5-
15P (15A, 125V) or NEMA 6-15P (15A, 250V) configuration.
3. The appliance coupler, flexible cord, and wall plug must bear a "T" mark
and registration number in accordance with the Japanese Dentori Law.
Flexible cord must be Type VCT or VCTF, 3-conductor, 0.75mm2 conductor
size. The wall plug must be a two-pole type with a Japanese Industrial
Standard C8303 (15A, 125V) configuration.
privacy statement
legal notices
http://h18000.www1.hp.com/athome/support/msgs/2000/pwrcord.html [12/10/2002 9:06:26 AM]
