Installation
PowerStorm 300 Graphics Options Windows NT and Hardware Installation 3–3
3.2.2 Installing the Option Module
The following section describes the installation procedure for either the PowerStorm
300/AGP or 300/PCI Graphics Controller option. To install the option, follow these steps:
__________________________ Note _____________________________
Before installing the graphics option, check your monitor specification for signal
compatibility and supported features offered by the graphics option.
____________________________________________________________
_________________________ Caution ___________________________
Static electricity can damage sensitive electronic components. When handling
your graphics option, use an antistatic wriststrap that is connected to a grounded
surface on your computer system. The wriststrap must be worn when handling
any module to prevent damage to the module.
____________________________________________________________
1. Shut down your computer system and disconnect the monitor cable.
2. Disconnect the power cord from your computer system.
3. Remove the cover from your computer (refer to your system documentation).
4. Put on an antistatic wriststrap.
5. If your computer has an existing graphics module, remove the screw that secures it
and then remove the module.
6. Refer to the documentation shipped with your workstation for information about
graphics option slots. Remove the slot cover if you are using a new slot.
7. Grasp the top edge of the graphics option and carefully insert it into the slot, then
firmly seat it.
8. Secure the module retaining bracket.
9. Replace the computer cover.
10. Ensure that the monitor cable is connected to the video output connector located on
the back of the graphics option.
11. Reconnect the power cord, and restart your computer system.
