. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
D-2
Appendix D: Regulatory Standards Compliance
Writer:
Chris Seiter
Project:
Appendix D: Regulatory Standards Compliance
Comments:
File Name:
1017A_D.DOC
Last Saved On:
6/26/97 3:16 PM
You may use unshielded twisted-pair (UTP) for RJ-45 connections. However,
use only shielded cable to connect I/O devices to this equipment via BNC
connection.
Warning:
•
Wear an anti-static wrist strap or take other suitable measures to prevent
electrostatic discharge whenever handling this equipment.
•
When connecting this hub to a power outlet, connect the field ground lead
on the tri-pole power plug to a valid earth ground line to prevent electrical
hazards.
The Interference Handbook
You may find the Interference Handbook prepared by the Federal
Communications Commission helpful. This booklet is available from the U.S.
Government Printing Office, Washington, D.C. 20402. Stock No. 004-000-
00345-4.You can also view this document on the World Wide Web at the
following address:
www.fcc.gov/Bureaus/Compliance/WWW/tvibook.html
NOTE
: In order to maintain compliance with the limits of a Class B digital device,
Compaq requires that you use a quality interface cable when connecting to this
device. Changes or modifications not expressly approved by Compaq could void the
users authority to operate this equipment. Suggested cable type is:
•
Twisted-pair for RJ-45 connections: 10Base-T
•
Thin Ethernet (50 ohm) for BNC connections: 10Base2
•
Thick Ethernet (D-type) for AUI connections: 10Base5
CE Mark Declaration of Conformance
This is to certify that this product complies with ISO/IEC Guide 22 and
EN45014. It conforms to the following specifications:
EMC: EN55022(1988)/CISPR-22(1985) class A
This product complies with the requirements of the Low Voltage Directive
73/23/EEC and the EMC Directive 89/336/EEC.
