4-2 N
EED
S
OME
H
ELP
?
I
PAQ C
ONNECTION
P
OINT
U
SER
G
UIDE
Symptom
Problem
Solution
I can’t see the iPAQ Connection
Point internal configuration
pages.
PC is set for static IP address
Re-run the configuration wizard.
If the problem persists, manually
check that dynamic IP addressing
is enabled.
Cabling—HPNA and Ethernet
• If you are using phoneline
networking, ensure that a
phone cable is connected
between the wall jack and the
lower, narrow RJ11 port on
the iPAQ Connection Point.
• If you are using Ethernet
networking, ensure that the
correct cables are connected
between the PC and the iPAQ
Connection Point, or between
the PC, the hub, and the iPAQ
Connection Point.
HomeRF security code
Ensure that the security code on
the iPAQ Connection Point internal
configuration page and the code
on the HomeRF client match.
Power to the iPAQ Connection
Point
Make sure the power cable is
fully plugged into the unit and the
power outlet.
Proxy is enabled
Make sure that the proxy feature
on the computer is disabled.
If you did not run the
configuration wizard, do so now.
Содержание iPAQ Connection Point CP-1
