Installation
2–2 ELSA GLoria Synergy Graphics Controller Installation Guide
2.3
Installation Procedure (Windows NT 4.0)
__________________________ Note ____________________________
If a graphics option other than the ELSA GLoria Synergy Graphics Controller
was previously operating in the system, keep that option installed and refer to
Section 2.3.2. If the previously installed graphics option is not available or it is
not operational, refer to Section 2.3.1.
___________________________________________________________
2.3.1
New Installation or Upgrade of Windows NT
Before installing the software drivers during a Windows NT upgrade or new installation,
install the ELSA GLoria Synergy Graphics Controller as described in Section 2.4. You can
then install Windows NT as described in the Windows NT documentation.
During Windows NT installation, a hardware and software component list is displayed,
like the one shown here:
Computer: Compaq Personal Workstation xxx (xxx = CPU type)
Display: VGA Compatible
Keyboard: XT, AT, or Enhanced Keyboard (83-104 keys)
Keyboard Layout: US
Pointing Device: Mouse Port Mouse
No Changes: The above list matches my computer
When you have completed the Windows NT installation, go to Section 2.3.2.
2.3.2
Software Driver Installation
If you have purchased the ELSA GLoria Synergy Graphics Controller as an add-on, you
must install the software drivers. Install the 2D and 3D drivers (the Compaq optimized
OpenGL support) from the included diskettes (or the Graphics Support Services Software
CD-ROM that will be included in future releases) by performing the following steps:
1.
Boot your system and log into Windows NT if you have not already done so.
2.
From the desktop, choose My Computer.
3.
From My Computer, choose Control Panel.
4.
From Control Panel, choose Display.
