2-10
Hardware Upgrades
Compaq Confidential - Need to Know Required
Writer:
Beth Zanca
Part Number:
191009-001
File Name:
e-ch02.doc
Last Saved On:
04/12/00 1:35 PM
Last Saved By:
Lydia Sanchez
✎
When replacing the subpanel, ensure that the aligning pins are
in their proper orientation.
✎
When converting from a minitower to a desktop orientation,
use the replacement subpanel that is shipped with your
workstation to ensure the Compaq logo is properly oriented.
Installing a Drive
Installing a Hard Drive into a 3.5-inch Drive Bay
✎
Compaq does not support mixing IDE and SCSI hard drives in
the same system. If you are replacing a hard drive in bay 4 or
bay 5, it should be of the same type.
To install a hard drive in a 3.5-inch drive bay:
1.
Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2.
Remove the Workstation access panel. Refer to Removing the
Workstation Access Panel in this chapter.
3.
Remove the Front bezel. Refer to Removing the Front Bezel in
this chapter.
