Page 3
Attaching the Mounting Brackets
Attach two mounting brackets, using the appropriate procedure
for the rack type.
WARNING: To reduce the risk of personal injury or equipment
damage during installation, never extend multiple
components installed in the rack at the same time. A rack
may become unstable if more than one component is
extended for any reason.
RETMA 41U Racks
1. Position each mounting bracket (see Figure 4,
1
) with the
rail holes pencil-marked M.
IMPORTANT:
Finger-tighten all three mounting bracket screws to
facilitate alignment. Then secure screws in the top and bottom
mounting bracket holes prior to securing the single screw at the rear of
the bracket. Ensure that the mounting bracket is parallel in the rack
from front to back.
2. Install a clip nut
2
and secure, using pan head SEMS
screws (10-32 x 5/8 inches).
RETMA 42U and Compaq Classic Racks
1. Connect an extender bracket to each mounting bracket (see
Figure 5) and finger-tighten two pan head SEMS screws
(10-32 x 5/8 inches).
2. Position each mounting bracket behind the vertical rail,
aligning it with the rail holes pencil-marked M.
3. Secure each mounting bracket using alignment washers and
pan head SEMS screws (10-32 x 5/8 inches) as shown in
Figure 6.
IMPORTANT:
Position each alignment washer to mate smoothly against
the vertical rail prior to fully tighting the screw.
4. Fully tighten the four screws installed in step 1 (see
Figure 5).
IMPORTANT:
To establish full strength of the extended bracket, ensure
that screws bonding the mounting bracket and extender bracket are
fully tightened prior to proceeding.
2
1
1
CXO6783B
2
4
CXO6784B
5
CXO6785B
6
