Compal HEL80, Руководство пользователя

Страница: 103 / 108

6 The BIOS Setup Program
6-10
Type the password and press the [Enter] key. You can type up to ten alphanumeric
characters. Symbols are ignored.
To confirm the password, type the password again and press the [Enter] key.
User Password Is / Supervisor Password Is
These two fields shows that User /Supervisor Passwords are set or not.
Set System Password is set.
Clear
System Password is not set.
Set Supervisor Password / Set User Password
Enter this field always shows the message.
While this field is highlighted, press “Enter”. The following message is shown:
Set Supervisor Password
Enter New Password [ ]
Confirm New Password [ ]
If there is an old password then setup will prompt with the following window instead and a
current password will be required to be entered at first:
Set Supervisor Password
Enter Current Password [ ]
Enter New Password [ ]
Confirm New Password [ ]
User can type password in field of “Enter New Password”, and re-enter password in field of
“Confirm New Password “ for verification.
If verification OK:
Setup Notice
Changes have been saved.
[Continue]
The supervisor password is set complete after user press “Enter”.
If verification fails:
Setup Warning
Passwords do not match.
Re-enter Password.
[Continue]
If password on boot is required, the password must be set otherwise it cannot be enabled.
The formats of the password are as follows:
Length:
No more than 8 characters.
Characters: Alphanumeric keys only. The shift status, Ctrl, Shift, Alt, and Capital, are
ignored.